Finally have a finished(ish) project to show off here!
So tonight I milled a wine rack for a little nook I have next to my microwave. Here's the pictorial:
Cut the pieces on the CNC
A little engraving, nice and minimal
Did a whole bunch of sanding, then gave it a coat of Danish Oil (thanks Rsilk!)
Standing up on it's own (I still have to work in a few dowels to make it stable)
In it's nook
It measures 36cm tall by 11.5cm wide.
You can find the EPS, the cutout Mach3 file and the engraving Mach3 file here:
http://signaltheorist.com/techworks/CNC ... ne%20Rack/
Things made on the CNC
1 post • Page 1 of 1