Page 1 of 1

Boxform

Posted: Fri Jun 08, 2012 9:58 am
by Hephaestus
Image

like this, still building the tops

Re: Boxform

Posted: Fri Jun 08, 2012 3:17 pm
by Hephaestus
Image

these are the parts i need to cut, modeled in Sketchup. they fit within a 20"x40" envelope with about an inch margin.

thoughts?

Re: Boxform

Posted: Fri Jun 08, 2012 10:17 pm
by rsilk
Looks like it should work fine. You'll probably want to insert tabs between your pieces when you run it through CAM so they don't start flapping about, but that's easy enough.