John tries to make a round end by hand.
It’s as easy as drawing a circle on an etch-a-sketch!
Rylan has asked me to post these links here. He will be doing two more lathe training sessions later this week. If you have not been trained already, the Thursday session is for you:
https://www.picatic.com/event14858074313497
and, if you already have the basic training, the advanced session on Saturday is for you:
https://www.picatic.com/event14858079182207
These training sessions are provided by Rylan at a cost of $50 per session.
The new laser cutter/engraver is up and running! It has a 40cm x 60cm cut area, and does a beautiful job of rastering.
I have tested it on plywood, hardboard, and Rowmark LaserMax with good results. Suggested settings will be collected on the Wiki as we determine them.